Products

Crushers & Shredders

PHK Chipper
PBEW Crusher
PSD Dbl. Shaft Shredder
PDB Single Shaft Shredder
PDWB Dbl. Shaft Crusher
PTR Drum Shredder
PSRH Horizontal Knife Mill

Granulators

Pulverizers

Agglomerators

Laboratory Mills

Ultra-Fine Grinding

 

Solutions by

Industry

Chemical

Food

Pharmaceutical

Plastics & Rubber

Mineral

Recycling

Wood

WPC

 

Crusher, type PBEW-"Dracula"

Pre-crushing of bulky waste  assortments

Method of Operation

The pre-crusher "Dracula" has a huge feed chute which at the same time serves as storage bin.  Depending on the installation of the machine, the type of feed material and the conditions of the site, the material can be fed into the storage bin by means of a front loader, a conveyor belt or another conveyor system.

The teeth of a slow speed rotor tear off parts of the large size material which them gets further crushed on the following auxiliary size reduction bars.

The crushed material is discharged out of the machine laterally, where by a grate determines the final particle size.  Special machine designs allow pre-crushing of whole particle board, MDF board piles.  According to customer's requirements the rotor can be driven either by an amply dimensioned gear motor, elastic coupling and multiple chain or by an hydraulic motor.

 

Advantages & Features

bullet

Slow speed rotor, extremely quiet operation and low dust generation due

bullet

Different crushing teeth patterns on the rotor adapted to material and requested degree of preparation

bullet

Easy feeding thanks to oversized storage bin

bullet

Simple re-armoring of the crushing teeth

bullet

Lateral material discharge; no expensive foundations are required

bullet

Trouble free operation, no bridging of material due to special devices installed on the storage bin

bullet

Sturdy rotor and drive make the machine resistant to foreign mater

bullet

Throughput capacity increase for downstream size reduction equipment due to reduced volume of feed material and consequently easier metering

bullet

After pre-crushing, large ferric contamination cam be easily separated

bullet

Special designs available for preparing piles of particle (MDF) board

bullet

Final particle size of pre-crushed material can be determined by different available machine configurations

Applications

  • Wood

  • Municipal waste

  • Plastic Waste

Technical Specifications

Type

PBEW

8-15

8-25 8-35 10-35

Infeed opening

mm

2300X1500

2300X2500 2300X3500 3300X3500

Rotor diameter

mm

800

800 800 1000

Rotor Length

mm

1500

2500 3500 3500

Drive Capacity

kW

45-55

55-75 75-90 132-160

Throughput rate *

Ton/h

6-10

10-15 14-20 20-30

* Throughput Rate based on screen size of 10 x 10 mm and may vary depending of the feed material

Home | About PALLMANN | Products | Solutions by Industry | Parts and Service | Contact Us | Sitemap


Quick Search:

2009 PALLMANN Industries, Inc.
PALLMANN Industries, Inc.
36 Atlantic Way, Clifton, New Jersey 07012 - USA
Phone: (973) 471-1450 - Fax: (973) 471-7152
Email: info@PallmannIndustries.com